MeldaProduction • Some questions about the modulation step editor

Hi folks,

I'm messing around for the first time with the step editor in the modulation section, and it's got some real interesting possibilities.

But i have a couple of questions.

The main thing that puzzles me is that when you put a curve on a step, it always goes to zero before the next step. At first i felt sure there must be a keyboard modifier that would allow me to set the depth of the curve but i couldn't find it. This seems like a big limitation.

As an example, if you take a look at the picture below, i want the curve on step 5 to only go down to the level of step six, not all the way down to zero (like it does in steps one & two). I've drawn this in with the yellow line.

Secondly, it seems undo only works sporadically in the step editor. Are there any trick or settings i could change to increase my chances of reliable undo?

Also, i find the the fact that the color reverses under the 50% line quite visually confusing, is there way to change this so that it keeps the same color all the way down to zero?

Thanks!

Statistics: Posted by Mr D — Sat Mar 02, 2024 10:09 am — Replies 0 — Views 25

---